Technical product record
Empty Load Detection Valve
Changes pneumatic response for unladen trailer operating conditions.
TCS part number9006040110
Portfolio familyAxle & Suspension
Load-sensitive trailer circuits.
Reference specification
Known product data.
Values shown are portfolio references for enquiry preparation. Confirm the released specification, variant and interfaces before ordering.
FunctionEmpty-load detection
MediumCompressed air
CalibrationApplication dependent
System context
Where this product sits in the control chain.
Manage trailer ride height, load-dependent pneumatic state and auxiliary-axle operation while preserving the intended braking architecture.
Suspension pressure, height or load input, electrical command and configured axle logic.
Lift or lower command, suspension air delivery or an output representing trailer load state.
Application decision record
What must be confirmed.
The review separates selection, installation and field evidence so responsibility and open points remain clear.
Selection inputs
- Axle count, suspension layout and lift-axle operating sequence
- Mechanical linkage geometry or electrical command logic
- Pressure, voltage, port and connector interfaces
- Automatic, manual and override behaviour required by the vehicle
Installation review
- Confirm ride-height datum and linkage travel without over-centre movement
- Verify hose routing through full suspension and steering travel
- Check raised and lowered axle states at relevant loads
- Protect electrical interfaces and confirm fail-state behaviour
Service evidence
- Loaded and unladen suspension-pressure observations
- Valve, cable or linkage position in each operating state
- Axle raise/lower sequence and delay
- Recent suspension, alignment or ride-height changes
Verification focus
Four checks that deserve an explicit record.
Discuss this recordEmpty Load Detection Valve
Empty Load Detection Valve
9006040110
Share the trailer, operating duty, current part evidence, quantity and destination. The applications team will identify remaining technical questions before quotation.
Request an application review →